濮阳市做网站,怎样用网站做淘宝客,丹东吧,多页网站制作1、问题现象 由于CentOS停止维护#xff0c;mirrorlist.centos.org网站也关闭不可访问。导致CentOS默认配置的yum.repos.d源也不可用#xff0c;所以执行yum命令会报“Could not resolve host: mirrorlist.centos.org”错误。具体如下#xff1a; Could not retrieve mirror…1、问题现象 由于CentOS停止维护mirrorlist.centos.org网站也关闭不可访问。导致CentOS默认配置的yum.repos.d源也不可用所以执行yum命令会报“Could not resolve host: mirrorlist.centos.org”错误。具体如下 Could not retrieve mirrorlist http://mirrorlist.centos.org/?release7archx86_64repoosinfrastock error was 14: curl#6 - Could not resolve host: mirrorlist.centos.org; 未知的错误 One of the configured repositories failed (未知), and yum doesnt have enough cached data to continue. At this point the only safe thing yum can do is fail. There are a few ways to work fix this: 1. Contact the upstream for the repository and get them to fix the problem. 2. Reconfigure the baseurl/etc. for the repository, to point to a working upstream. This is most often useful if you are using a newer distribution release than is supported by the repository (and the packages for the previous distribution release still work). 3. Run the command with the repository temporarily disabled yum --disablereporepoid ... 4. Disable the repository permanently, so yum wont use it by default. Yum will then just ignore the repository until you permanently enable it again or use --enablerepo for temporary usage: yum-config-manager --disable repoid or subscription-manager repos --disablerepoid 5. Configure the failing repository to be skipped, if it is unavailable. Note that yum will try to contact the repo. when it runs most commands, so will have to try and fail each time (and thus. yum will be be much slower). If it is a very temporary problem though, this is often a nice compromise: yum-config-manager --save --setoptrepoid.skip_if_unavailabletrue 二、解决办法 通过一下命令使用新文件替换CentOS原有的CentOS-Base.repo文件。
#先备份原来的CentOS-Base.repo文件
mv /etc/yum.repos.d/CentOS-Base.repo /etc/yum.repos.d/CentOS-Base.repo_old#从阿里云下载新文件替代CentOS-Base.repo
curl -o /etc/yum.repos.d/CentOS-Base.repo http://mirrors.aliyun.com/repo/Centos-7.repo#重建yum元数据缓存大约需1分钟
yum makecache以上完成后yum命令即可正常使用。
